Affiliate disclosure: the "Get this deal" button is an affiliate link to the store. If you buy through it we earn a commission at no extra cost to you. Full policy
MORG BB 85110 Black Friday pricing from Evertone Project is 40% off this EQ plugin, which brings it to $50.40 until Nov 30, 2026.
It pairs two stepless parametric peak bands with two stepped shelving bands, and it captures two real hardware units, down to how their potentiometers behave.
The peak bands use an interactive proportional-Q response. Narrow the bandwidth and the gain height rises with it. The input side adds smooth, discrete mic and line drive characteristics.
Because every section works independently, you can engage only the shelves, only the peaks, or both at once. Bypass both and the active preamp path stays in the signal chain.
The low peak band covers 40 to 400 Hz and the high peak band covers 0.6 to 6 kHz. Both have fully stepless Gain, Frequency and Q controls.
The x3 multiplier buttons stretch each band's range upward. The Q and gain you have already set stay where they are.
The shelving bands are stepped instead of continuous. The low shelf offers 33, 56, 95, 160 and 270 Hz. The high shelf offers 3.3k, 4.7k, 6.8k, 10k and 15k Hz.
The mic stage gives you 0 to +60 dB of gain, with a continuous Trim control adding 0 to +20 dB on top. The line stage is independent and runs from -18 to +18 dB.
Module #1 and Module #2 are the two hardware profiles you can switch between. PAIR mode uses both, so a stereo track gets the small component differences you would hear between two real channels.
The high-pass filter spans 36 to 330 Hz and the low-pass filter spans 3.9k to 16 kHz. A PHASE switch flips polarity, and Full and Lite modes set the processing quality.
Yes. The MORG BB 85110 Black Friday deal takes 40% off, which brings it to $50.40. The offer ends Nov 30, 2026. It is a saturation and EQ plugin from Evertone Project.
It has two stepless parametric peak bands, two stepped shelving bands, mic and line input stages, and high-pass and low-pass filters. You also get x3 frequency multipliers, phase inversion, a PAIR mode and Full/Lite quality modes.
The low peak band spans 40 to 400 Hz and the high peak band spans 0.6 to 6 kHz. The low shelf steps through 33 to 270 Hz, and the high shelf steps through 3.3k to 15k Hz.
PAIR mode activates both hardware profiles, Module #1 and Module #2, together. The maker says this gives realistic channel-to-channel component variance in stereo, rather than two identical sides.
Prices and end dates are checked at publishing time and can change, so confirm them at the store before you buy.