
Affiliate disclosure: the "Get this deal" button is an affiliate link to the store. If you buy through it we earn a commission at no extra cost to you. Full policy
The Amplifikation ARKHIVE Black Friday deal takes 48% off Kuassa's amp simulator plugin, so it costs $25 until Nov 30, 2026.
ARKHIVE is a guitar amp plugin built around the three-channel structure of the MK5* amplifier. Kuassa says it reproduces that amp's versatility, tonal depth and dynamic range inside your DAW.
The maker pitches it as analog-inspired tone with modern production tools, shaped from one single-screen interface.
The plugin carries three amps, and each one has three channels.
The power amp section has Sag and Bias controls, which change how the virtual power stage reacts when you play hard.
There is a five-band equalizer on board, plus a low pass filter and a high pass filter. A built-in noise gate and limiter sit in the same chain.
The speaker side offers five cabinet types, using impulse responses taken from matching cabinets. You choose from nine workhorse mic types.
Mics can be set up as a dual-mic pair with mono or stereo output. A mix control blends the two, which mirrors how a real guitar recording session gets miked.
Oversampling goes up to 8x, which is useful when you push the high-gain channels and want to keep aliasing in check, though it costs more CPU.
ARKHIVE is also available as a module inside Amplifikation 360.
On Windows, you need Windows 7 or later, 64-bit only, a VST or VST3 compatible host, and 4 GB of RAM. The processor requirement is a Core2Duo or AMD Phenom II X4 or better, and a recent Intel i3 or AMD A4 is recommended.
On Mac, it needs macOS 10.11 or later, 64-bit only, with Intel and Apple Silicon both supported. Hosts can use VST, VST3 or Audio Units, and 4 GB of RAM is the minimum.
If you work in Pro Tools, the AAX format needs Pro Tools 11 or later.
Yes. The Amplifikation ARKHIVE Black Friday deal gives 48% off Kuassa's amp simulator plugin, bringing it to $25, and it runs until Nov 30, 2026. The plugin has three amps with three channels each.
It has three amps with three channels each, a five-band EQ, low pass and high pass filters, a noise gate and a limiter. On the speaker side you get five cabinet types and nine mic types, with a dual-mic setup.
It runs as VST or VST3 on Windows, and as VST, VST3 or Audio Units on Mac. AAX is supported too, but that needs Pro Tools 11 or later. Both platforms are 64-bit only.
Amp A has Clean, Fat and Tweed voicings. Amp B has Edge, Crunch and Overdrive. Amp C goes for heavy high gain and adds an extreme mode. Each amp also has its own Mod setting for different voicings.
Prices and end dates are checked at publishing time and can change, so confirm them at the store before you buy.